Mask & Fursuit Headstrap | 1.5 Inch Width, Three Way Plastic Assembly

Safety Information

3D-Printed 3-Way Costume Mask Strap

This product is a costume/cosplay accessory designed to connect or route straps on a costume mask or similar costume headpiece. It is not a toy or protective safety device.

Use and Handling

* Inspect the strap connector before each use for cracks, breaks, deformation, or other visible damage.
* Ensure all straps are correctly routed through the connector and securely positioned before wearing the mask.
* Do not overtighten the straps or apply excessive force to the connector.
* Do not use the connector if it is cracked, broken, significantly deformed, or otherwise damaged.
* Replace the connector if significant wear or damage develops.
* Do not cut, drill, melt, heat, or otherwise modify the connector in a way that could compromise its structural integrity.
* Keep the product away from open flames, sparks, candles, heaters, and other sources of excessive heat.
* Do not intentionally heat or melt the connector.
* Clean with mild soap and water when necessary and allow it to dry completely.
* Keep away from young children. This product is a costume accessory and is not intended to be used as a toy.
* Keep away from pets and do not allow animals to chew on the product.

Warning

A damaged or improperly installed strap connector may cause the costume mask to loosen or detach unexpectedly. Always inspect the connector and strap system before use.

This product is not designed, tested, or certified as personal protective equipment, respiratory protection, or a safety restraint.